!   TITLE:  gimb_therm_up_az_calib.parm (AAAV)
!
!---------------------------------------------------------------------------
!       Rev -   07/29/2000      J. Rinaldi
!---------------------------------------------------------------------------
!
!   This is the parameter file used in the construction of the azimuth
!   gimbal of the AAAV, GIMBAL.MAC.
!
!--------------------- a.) Part Name Selection Variable --------------------
!
name='gimbal'
arry_nam='gimb'
!
!--------------------------- b.) Model C.S. Names --------------------------
!
ct_name='CSgim0'            ! cartesian
cyl_name='CSgim1'           ! cylindrical
sph_name='CSgim2'           ! spherical
!
!---------------------------------------------------------------------------
!
pcnt_act=100                ! upper rectangular section size percent of the
!                           ! actual width dimensions
!
dhubo=4.925                 ! diameter of the outer hub
!
l5=4.680
l6=4.505
l7=3.623
!
l9=0.562
l10=1.658
l11=5.961
!
r2=(4.635/2)-.138/2-.030        ! radius parameters
!
!
n=9               ! # of inner surface cuts around the perimeter
dpth_cut=.125     ! depth of cuts into inner surface
r_cut=.062        ! Radius of cuts
astart=-90        ! Angle to 1st cut from positive X-axis
rgap=.015         ! Edge of hole distance from gimbal bore
ainc=22.5         ! Angle between cuts (use 360/n for equally spaced)
                  ! See rpat below for radius of hole pattern
!
! Outer Race of Lower Azimuth Bearing (490A045-102, Rev. B)
!
rracei=.9991027367795997 ! Equiv. Inner radius (from ring.mac & press.tkw(ri))
rraceo=2.16525/2    ! Outer radius (from 490A045-102)
trace=rraceo-rracei ! Euiv. thickness of bearing outer race

!
! Steel Sleeve
!
tslv=.08715             ! Thickness of sleeve
rslvi=rraceo            ! Inner radius of steel sleeve
rslvo=rslvi+tslv        ! Outer radius

!
! Epoxy Layer
!
tepoxy=.003             ! Bond layer thickness of epoxy
repoxyi=rslvo           ! Inner radius of bond layer
repoxyo=repoxyi+tepoxy  ! Outer radius of bond layer

!
! Azimuth Gimbal Bore
!
r_gbor=r2           ! Inner radius of azimuth gimbal bore
r_hub=1.500         ! Outer radius of azimuth gimbal center hub

!
! Azimuth gimbal Outer Configuration
!
width=4.642             ! Width of rectangular section
dfront=.1               ! Distance from az axis to front of rect.
dback=1.658+.562        ! Distance from az axis to back of rect.
dcut=2.1657/2+.25       ! Front clearance cut dist. from bearing bore

rpat=r_gbor+(r_cut+rgap)